Light＆License plate-Relocation kit RH1250S SportsterS

A stay KIT that can clean up the unstylish genuine rear area and emphasize the rear tire. A set of side license plate KIT, turn signals, and tail relocation stay. For turn signals, we recommend the Kellermann Bullet Atto DF, which has an integrated tail and turn signal. If you use the optional 15mm extension, it will also meet vehicle inspection requirements. Please use the existing extension wiring for wiring. Some items have thin wires, so we recommend using soldering as well. Depending on the turn signal and tail installed, phenomena such as high flash may occur. In that case, take measures such as adding a resistor.

[Size]
turn signal stay Width: approx. 114mm Length: approx. 55mm Height: approx. 25mm When license plate stay installed: Width: approx. 230mm Length: approx. 160mm Height: approx. 130mm

[Material]
Stay: steel　License plate stay: aluminum　License plate light: resin


NOTE-------------------
*There are restrictions on shipping size depending on the country you are shipping to.
*If the size limit is exceeded, the shipment may not be possible.
*Gas tanks and suspensions may not be shipped by air.
*If the shipment is refused, we will change to shipping by sea.
*If a country cannot be shipped by sea, the order itself may be cancelled.

----------------------
[IF THE ITEM IS SOLD OUT]
Please click "request restock notification".
* Please feel free to contact us if you need to know the delivery date.

POST

SHARE

LINE

Report